4 Operation
Checks prior to starting work
Instructions for running-in
The forklift truck can be run at high speeds
straight away. However, in the first 50 operat-
ing hours avoid subjecting either the operating
hydraulics or the traction drive to high contin-
uous loads . In the initial operating period and
after every wheel change tighten the wheel
fastenings before start-up, and then every 10
operating hours until they have settled into
position, i.e. retightening is no longer possible
. And then every 100 operating hours. The
wheel fastenings should be tightened cross-
wise with a torque of
front:
210 Nm
rear:
210 Nm
NOTE
Observe the tightening instructions on the tag
attached to the steering column
Checks prior to starting work
¾ Check charge state of battery
¾ Check braking system and parking brake
¾ Check electrical system (
lights, windscreen
wipers, horn, heating)
¾ Check condition and function of driver’s
seat and seat belt
¾ Check tyres
24 Operating Instructions – 386 807 1001 EN – 03/2006
To Next Page
Loading...
