HOME AUTOMATION OUTPUT FLASHES DURING AND AFTER ALARM
★ The factory setting causes the Console’s
Home Automation Output to activate when
pressing the [AUTO] key, or when it’s
triggered with a two-button remote control.
★ In addition, the Console can be
programmed to flash the Home Automation
Output during and after any alarms.
★ The output will continue to flash until the
flashing status lights are cleared.
★ The Console must be in Learn Mode to
make this change.
☞Exit Learn Mode when all programming
changes are complete.
REMOTE CONTROL ARM/DISARM CHIRP
★ When arming with the portable remote
control, the factory setting causes the
Console to “chirp” once when armed, twice
when disarmed, and three times when
arming with sensors bypassed.
★ Alternately, these chirps can be silenced.
★ If these chirps are silenced, it is
recommended to program the Home
Automation Output to be active when the
system is armed, so a light can be triggered
displaying the arming status of the Console.
★ The Console must be in Learn Mode to
make this change.
☞Exit Learn Mode when all programming
changes are complete.
HOME AUTOMATION ACTIVATION TONE
★ The factory setting causes the Console to
sound a “bing” when the Home Automation
Output is activated by pressing the [AUTO]
key, or when it’s triggered with a two-button
remote control.
★ Alternately, this sound can be silenced.
★ The Console must be in Learn Mode to
make this change.
☞Exit Learn Mode when all programming
changes are complete.
33 OF 40
PROGRAMMING STEP #72
PROGRAM
STORE PROGRAM
0 FOR STANDARD TRIGGER
1 FOR FLASHING ON & AFTER ALARM
PROGRAMMING STEP #74
PROGRAM
STORE PROGRAM
0 FOR BING TONE OFF
1 FOR BING TONE ON
PROGRAMMING STEP #73
PROGRAM
STORE PROGRAM
0 FOR CHIRPS OFF
1 FOR CHIRPS ON
Defiant SSD DF-16 Owner’s Manual
Linear P/N: 208968 C
Material: 20# White Mead Bond with 60# White Coated Cover
Ink: PMS 548 (Blue/Gray)
Size: 8 1/2" x 5 1/2"
31
To Next Page
Loading...
