M565Li OWNER’S/OPERATOR’S MANUAL
16. MAINTENCE
78
6.
Rinse off any remaining soap, squeeze the excess solvent out of the sponge
material and let it dry.
7.
Replace filter if required.
8.
Spray foam air filter oil generously onto air filter and work the oil into the filter.
For the best results you can use Maxima FAB-1 or Maxima FFT foam filter oil.
9.
Squeeze the element to remove excess oil. The sponge material should be
wet but not dripping.
10.
Reinstall air filter into the air box and tighten the clamp. Do not over tighten
the clamp or filter damage may occur.
Steering Inspection
The steering assembly of the machine should be checked periodically for loose
nuts and bolts. If loose nuts and bolts are found, have your dealer tighten them
before riding your ATV.
Camber and Caster
The camber and caster are non-adjustable.
Do not attempt to adjust the tie rod for toe alignment. Severe injury or
death can result from improper adjustment. Contact your dealer. Dealer
has the training and tools to make these adjustments.
Toe Alignment Check
The recommended toe alignment is 3-6mm toe out.
1.
Set the handlebars in a straight ahead
position and hold them in this position.
2.
Measure A and B. A minus B should
be 1.5-3 mm.
3.
If this measurement needs to be adjusted,
contact your dealer for service.
To Next Page