Linksys SPA9000 User Manual

50
Chapter 6: Using the Web-based Utility
The Voice Tab
IP Telephony System
Ring6 Cadence. This is the cadence script for distinctive ring 6. The default is 60(.2/.4,.2/.4,.2/4).
Ring7 Cadence. This is the cadence script for distinctive ring 7. The default is 60(.4/.2,.4/.2,.4/4).
Ring8 Cadence. This is the cadence script for distinctive ring 8. The default is 60(0.25/9.75).
Distinctive Call Waiting Tone Patterns
CWT1 Cadence. This is the cadence script for distinctive CWT (Call Waiting Tone) 1. The default is 30(.3/9.7).
CWT2 Cadence. This is the cadence script for distinctive CWT2. The default is 30(.1/.1, .1/9.7).
CWT3 Cadence. This is the cadence script for distinctive CWT3. The default is 30(.1/.1, .3/.1, .1/9.3).
CWT4 Cadence. This is the cadence script for distinctive CWT4. The default is 30(.1/.1,.1/.1,.1/9.5).
CWT5 Cadence. This is the cadence script for distinctive CWT5. The default is 30(.3/.1,.1/.1,.3/9.1).
CWT6 Cadence. This is the cadence script for distinctive CWT6. The default is 30(.1/.1,.3/.2,.3/9.1).
CWT7 Cadence. This is the cadence script for distinctive CWT7. The default is 30(.3/.1,.3/.1,.1/9.1).
CWT8 Cadence. This is the cadence script for distinctive CWT8. The default is 2.3(.3/2).
Distinctive Ring/CWT Pattern Names
Ring1 Name. In an INVITE’s Alert-Info header, this is the name that picks distinctive ring/CWT 1 for the inbound
call. The default is Bellcore-r1.
Ring2 Name. In an INVITE’s Alert-Info header, this is the name that picks distinctive ring/CWT 2 for the inbound
call. The default is Bellcore-r2.
Ring3 Name. In an INVITE’s Alert-Info header, this is the name that picks distinctive ring/CWT 3 for the inbound
call. The default is Bellcore-r3.
Ring4 Name. In an INVITE’s Alert-Info header, this is the name that picks distinctive ring/CWT 4 for the inbound
call. The default is Bellcore-r4.
Ring5 Name. In an INVITE’s Alert-Info header, this is the name that picks distinctive ring/CWT 5 for the inbound
call. The default is Bellcore-r5.
Figure 6-28: Voice - Regional Screen - Distinctive Call
Waiting Tone Patterns
Figure 6-29: Voice - Regional Screen - Distinctive
Ring/CWT Pattern Names
VoIPon Solutions www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0) 1245 600560

Linksys SPA9000 Specifications

Physical Interfaces

Ethernet ports	2 10/100BaseT RJ-45
Phone ports	2 RJ-11 FXS
Ring voltage	40-55 VRMS
Ring frequency	10 Hz - 40 Hz
Maximum ringer load	3 REN

Power

On-hook voltage	-50 V NOMINAL
Off-hook current	25 mA min
Terminating impedance	Configurable, including 600 ohms