Linn Akurate Kontrol Specification And Commands

Akurate Kontrol pre-amplifier - RS232 ASCII Interface Specification and Commands - Version 1.2
7
System Commands
The following commands allow the Akurate Kontrol to be part of a system driven through an RS232 interface.
1.5: Identity Commands
1.5.1: ID
Configure the product on a one to one basis
 $ID identifier$
 $ID identifier$
 Write product identifier
 $ID ~identifier$
 $ID$
 Remove product identifier
 $ID ?$
 $ID identifier$
 Return product identifier
1.5.2: GID
Configures a product as part of a group so that it can be accessed a number of ways
 $GID identifier$
 $GID identifier$
 Write group identifier (product now becomes part of a group of products)
 $GID ~identifier$
 $GID identifier [identifier […]]$
 Remove a product from a particular group
 $GID ?$
 $GID identifier [identifier […]]$
 Return list of currently defined group identifiers from product
Notes on Groups:
A product can be a member of at most 5 groups to allow it to be addressed in a variety of ways.
While in group mode, products with the same group ID will react in the same way to product specific
commands sent to them using the Group_ID syntax (&group_id&).
In addition, products in Group Mode will not acknowledge receipt of commands from the host. This is to avoid
all products in the group potentially responding at the same time.
Each product can be polled individually at the end of a group mode command to check they have all been
updated correctly.

Linn Akurate Kontrol Specifications

General

Brand	Linn
Model	Akurate Kontrol
Category	Amplifier
Language	English