Introduction
This document describes how to control the Akurate Kontrol pre-amplifier and peripherals through an RS232
interface.
Please note that the information contained in this document is preliminary and will be subject to
change.
There are three main sections to this document:
1: Message Protocol
- This section describes how commands are constructed and how they may be used.
System Commands
- This section lists the commands, which allow the Akurate Kontrol to be used as part of a system
driven through an RS232 interface.
2: System Commands
- This section defines a list of commands for controlling the Akurate Kontrol. This section is further
subdivided into the subsets of the Akurate Kontrol commands.
To Next Page
Loading...
Need help?
General
