Lippert Power Bimini Master - Page 44

Rev: 08.30.22 Page 44 CCD-0006500
What Is Happening? Why? What Should Be Done?
Top does not raise or
lower.
No power. Turn on boat's electrical power.
Bad electrical harness.
Contact Lippert.
Bad actuator.
Bad electrical
connection.
Check for loose or unconnected wires.
Connect wires.
Pinched/cut harness
wire.
Replace wires/wire harness.
Bad controller. Contact Lippert.
Touch-sensitive
controller power
indicator light not lit.
No electrical power. Turn on boat's electrical power.
Bad light. Replace controller.
Touch-sensitive
controller buttons do
not respond.
No electrical power. Turn on boat's electrical power.
Bad electrical
connection.
Check for loose or unconnected wires. Connect
wires.
Pinched/cut harness
wire.
Replace wires/wire harness.
Bad controller. Contact Lippert.
Mesh top sags.
Unzipped frame
pocket.
Zip all frame pockets closed.
Unconnected snap(s). Connect all snaps.
Mesh top not fully
opened.
Fully open mesh top.
Front shade extension
stanchions do not reach
the locking plates.
Front shade extension
not fully extended.
Fully extend front shade extension.
Bimini top not fully
extended.
Fully extend bimini top.
Locking plates
mounted too far away.
Relocate locking plates.
Stanchions do not lock
in-place.
Bad locking button. Contact Lippert.
Tie-down strap does not
reach the saddle.
Saddle mounted too far
away.
Relocate saddle.
Tie-down strap not
extended enough.
Adjust tie-down strap buckle to increase strap
length.
Tie-down strap clip does
not close on saddle or
stanchion.
Bad spring clip. Replace tie-down strap.
Bimini top does not
respond to key-fob.
Weak signal. Move key-fob closer to RF Receiver.
No power.
Check power connections to RF Receiver.
Reconnect power if necessary. Refer to figure 8
and Wiring Diagram.
Use helm switch. If top responds to helm switch,
replace key-fob battery.