Lippert SlimRack Plus - Operation; Prior to Moving the Slide-Out Room; Extending the Slide-Out Room; Retracting the Slide-Out Room

Rev: 06.14.24 Page 4 CCD-0007721
Operation
Always make sure that the slide-out room path is clear of people and objects before and
during operation of the slide-out room. Always keep away from the gear racks when the slide-out
is being operated.
Prior to Moving the Slide-Out Room
• Make sure the engine or generator is running to ensure ample voltage is being supplied to the slide-out
room controller.
• On a towable unit, make sure the batteries are fully charged to ensure ample voltage is being supplied to
the slide-out room controller.
• Set the parking brake, if applicable.
Extending the Slide-Out Room
1. The engine or generator must be running or unit must be plugged into shore power.
2. Transmission must be in park or neutral (if applicable).
3. If applicable, set the park brake and level the unit.
4. If equipped, remove the transit bars.
5. If equipped, turn "on" the on/off switch or key.
6. Press and hold the switch in the EXTEND position (Fig. 1). There will be a slight delay before the slide-
out room will begin to move. This is normal.
7. Release the switch button when the slide-out room is fully extended and stops moving.
NOTE: Once the room has stopped moving, it is not necessary to press the switch a second time.
8. If equipped, turn "off" the on/off switch or key.
Retracting the Slide-Out Room
1. The engine or generator must be running or the unit must be plugged into shore power.
2. Transmission must be in park or neutral (if applicable).
3. If applicable, set the park brake and level the unit.
4. If equipped, turn "on" the on/off switch or key.
5. Press and hold the switch in the RETRACT position (Fig. 1). There will be a slight delay before the slide-
out room will begin to move. This is normal.
6. Release the switch button when the slide-out room is fully retracted and stops moving.
NOTE: Once the room has stopped moving, it is not necessary to press the switch a second time.
7. If equipped, turn "off" the on/off switch or key.
8. If equipped, install the transit bars.
Fig. 1
Retract
Extend