Rev: 06.14.24 Page 5 CCD-0007721
Modes
The SlimRack Plus Slide-Out controller has multiple operating modes.
Normal Operating Mode
This is the operating mode which extends and retracts the slide while maintaining synchronization between the
two sides. The controller will self-synchronize, detect end-of-travel, detect and store faults and electronically
protect the slide-out when certain faults are detected.
Electronic Override Mode
This operating mode will disable fault detection. The slide-out motors will be driven without electronic
protections. The slide-outs will not self-synchronize or detect end-of-travel.
NOTE: Use caution in electronic override mode, electronic protections will be disabled.
NOTE: Driving the flanges of the slide-out into the RV wall could result in damage. Driving a single motor
and skewing the slide-out box could result in damage.
1. To enter electronic override mode, press the on-controller mode button (See Mode Button Functions
section) seven times and hold on the last press. The LEDs will rapidly blink one after another while the
mode is active.
2. The controller can be returned to normal operating mode by pressing and holding the mode button
on the controller for at least one second, or will return to normal operating mode on its own after two
minutes, even if the slide is being driven.
3. To independently drive either side, unplug one of the opposite side’s motor connectors. To move both
sides at the same time, ensure both connectors are connected.
When connecting power to the motor, ensure the motor spade terminals are connected before attaching
12V power and ground. Attaching 12V power or ground directly to the motor inputs can damage the
controller.
To Next Page
Loading...
