Rev: 06.14.24 Page 9 CCD-0007721
Troubleshooting
The SlimRack Plus Slide-Out controller detects several faults. LEDs on the controller are used to indicate when
the controller is driving a slide-out and faults. The QR code on the controller can be scanned with a mobile
phone camera and leads to more troubleshooting documentation (Fig. 7).
NOTE: When in electronic override mode, electronic protections will be disabled.
Mode Button Functions
The mode button (Fig. 7) is used to perform a factory reset of the controller and switch between operating
modes.
To use the mode button, press it the number of times needed to get to the desired function and hold on
the last press for 1 second. With each press, the green and red LEDs will both illuminate. When pressed and
held, the LEDs will remain illuminated for 1 second, then turn off. Consecutive presses must be made within
1 second.
Examples:
• Press x 6, press and hold – Enters electronic override mode.
• Press and hold (when in electronic override mode) – returns to normal operating mode.
• Press x 4, press and hold – Performs factory reset.
Fig. 7
QR Code
Mode Button
To Next Page
Loading...
