TP0003B
Liquid Controls
It is the aim of Liquid Controls to maintain a policy of continuous progress and for this reason Liquid
Controls reserves the right to modify specifications without notice. This manual provides the information
required to install, service and overhaul the equipment. Although every effort has been made to
ensure absolute accuracy, Liquid Controls does not hold itself responsible for any inaccuracies that
may be found.
PRODUCT SAFETY
In the interest of safety it is strongly recommended by Liquid Controls that the following details receive
strict attention.
For the Purpose of Definition, the word PRODUCT applies to any product sold by Liquid Controls.
1
The Produc
t is used only with fluids stated as acceptable by Liquid Controls.
2
The Product, while in service, must not be subjected to pressures greater than the Maximum
Working Pressure or tested to pressures greater than the Test Pressure as specified in the manual.
3
The Product must only be coupled/connected to equipment c
onsidered acceptable by Liquid Controls.
4 The Product must be handled using the lifting handles where fitted, or in accordance with the
manual.
5 The Product must not be misused or handled in any way liable to cause damage.
6 The Product must be inspected for any signs of damage prior to use e.g. cracks, damaged seals,
seized or tight operating mechanisms.
7
The Product must be subjected to a regular maintenance program, either in accordance with the
manual or as agreed with Liqu
id Controls.
8 Only technically competent personnel should repair or maintain the Product and only parts supplied
by Liquid Controls may be used.
9
Products c
overed by warranty may not be modified in any way without prior written permission of
Liquid Controls.
10 Products not in service, must be stored in a clean area, and should not be subjected to excessive
temperature, humidity, sunlight, or strong artificial light. Products should be protected to prevent
damage or the ingress of foreign matter.
11 Where applicable, attention should be drawn to dangers
resulting
from
the generation of static
electricity in product flow lines.
12 This equipment is not suitable for use with Liquid Petroleum Gas (L.P.G).
Page (v)/(vi)
To Next Page
Loading...
Need help?
General
