41
DIP switch A2 is used to set the analog input type as voltage or current.
DIP switch AM is used to set the analog output type as voltage or current.
AC (Analog Common) is the common terminal of analog signal.
DIP switch RS-485 is used to set RS-485 termination resistor. Switch it ON in the last drive
when using a single drive to run more than one motor.
RJ45 is the communication port for RS-485.
USB port is used to connect to a PC through a USB cable.
Analog output is used to connect a frequency meter, current meter, voltage meter and power
meter.
4.3.1 Control Circuit Terminals
To Next Page
Loading...