LiteOn EVO 8000 Series - Page 67

64
Parameter
Name
Description
Setting Range
A2-12
E2-01
Relay2function selection
A2-13
E3-00
Analog A1 input signal
A2-14
E3-01
Analog A1 function
A2-15
E3-06
Analog A1 function
A2-16
E3-07
Analog A2 function
A2-32
User-Defined
Parameter
Automatic Save
Saves the most recently edited parameters.
0: Do not save list of recently edited parameters
1: Save list of recently edited parameters
Default: 0
Range: 0, 1
Group b, Application
b1: Operation Mode Selection
b1-00
Frequency
Command Selection
1
0
∶
Keypad
1
∶
Control Circuit Terminal (Analog Input)
2
∶
Terminal Up/Down
3
∶
Modbus Communication
4
∶
Pulse Train Input (Including PWM signal input)
5 : Reserved
6 : CANOpen
Default
∶
0
Min.: 0
Max.: 6
b1-01
Run Command
Selection 1
0
∶
Keypad
1
∶
Control Circuit Terminal (Sequence Control
Input)
2
∶
Modbus Communication
3: Expansion card
Default
∶
0
Min.: 0
Max.: 3
b1-02
Stopping Method
Selection
0
∶
Ramp to Stop
1
∶
Coast to Stop
2
∶
DC Braking to Stop
3
∶
Coast to Stop with Timer
Default
∶
0
Min.: 0
Max.: 3
b1-03
Reverse Rotation
Selection
0: Reverse Rotation Enabled
Drive accepts a run command of both forward
and reverse directions
1: Reverse Rotation disabled
Drive can accept only run command of
forward direction
Default: 0
Range: 0, 1
b1-04
<9>
Zero speed
operation
When the frequency command is lower than the
set value of d1-08, and the running command still
exists, when the motor decelerates and is lower
than the set value of d1-08, the zero speed
operation is performed.
Default: 0
Range: 0, 1
b1-05
Run Command
0: Ignore Active Run Command at the New Source
Default
∶
0