LiteOn EVO 8000 Series - Page 84

81
Parameter
Name
Description
Setting Range
speed reaching the speed limit, increase the set
value.
L5-07
Proportional gain
adjustment factor
for current control
(ACR)
Set the override of the current controller
proportional gain, please try to avoid changing it.
Default ∶ 1.00
Min.∶ 0.00
Max.∶ 100.00
L5-08
Set the override of
the current
controller
proportional gain,
please try to avoid
changing it.
Sets the current controller integral gain
magnification, please try to avoid changing it.
Default ∶ 1.00
Min.∶ 0.00
Max.∶ 100.00
L5-09
Current loop
bandwidth
Default ∶ 120 Hz
Min.∶ 0 Hz
Max.∶ 400 Hz
L5-10
Current trap Q
value
Default ∶ 0.5
Min.∶ 0
Max.∶ 1.0
L5-11
Current trap center
depth
Default ∶ 0.01
Min.∶ 0
Max.∶ 1.000
L5-12
Current trap
bandwidth
Default ∶ 1.0 Hz
Min.∶ 0 Hz
Max.∶ 500.0 Hz
L5-13
Current trap switch
Default ∶ 0
Min.∶ 0
Max.∶ 1
L6: Offset Frequency
L6-00 <4>
Offset Frequency 1
Sets the offset value as a percentage of the
maximum output frequency to add to or subtract
from the frequency command.
Select the offset frequency in E1-□□= 53, 54 and
55 (Offset Frequency 1 to 3).
Default: 0.0%
Min.: -100.0%
Max.: 100.0%
L6-01 <4>
Offset Frequency 2
Sets the offset value as a percentage of the
maximum output frequency to add to or subtract
from the frequency command.
Select the offset frequency in E1-□□= 53, 54 and
55 (Offset Frequency 1 to 3).
Default: 0.0%
Min.: -100.0%
Max.: 100.0%
L6-02 <4>
Offset Frequency 3
Sets the offset value as a percentage of the
maximum output frequency to add to or subtract
Default: 0.0%
Min.: -100.0%