LiteOn EVO600043S1D5E20F User Manual

143
o2 Multi-Function Selection
o2 parameters determine the functions assigned to the keys on the keypad.
 o2-01 STOP Key Function Selection
Determines if the STOP key on the keypad will stop the drive when Remote is selected as the
command source.
No.
Name
Setting Range
Default
o2-01
STOP Key Function Selection
0, 1
1
0 : Disabled
1 : Enabled
The STOP key always stops drive operation even if the command source is not set to the
keypad. To restart the drive,cycle the Run command if the drive has been stopped by pressing
the STOP key.
 o2-02 Retain
 o2-03 Drive Capacity Selection
Set this parameter after replacing the terminal block or drive modules.
CAUTION! An incorrect o2- 03 setting may cause the drive performance to suffer and drive damage.
No.
Name
Setting Range
Default
o2-03
Drive Capacity Selection
<1>
Determined by drive capacity
<1> Table for the setting range
Rating (kW)
(200V series)
0.25
0.4
0.75
1.5
2.2
o2-03 Setting
0
1
2
3
4
Rating (kW)
(400V Series)
0.25
0.4
0.75
1.5
2.2
o2-03 Setting
32
33
34
35
36
 o2-04 ENTER Key Function During Frequency Command Setting
Determines whether the ENTER key is required to be pressed after changing the frequency
command using the keypad in Local mode.
No.
Name
Setting Range
Default
o2-04
ENTER Key Function During Frequency Command Setting
0,1
0

LiteOn EVO600043S1D5E20F Specifications

General

Brand	LiteOn
Model	EVO600043S1D5E20F
Category	Controller
Language	English