LiteOn EVO600043S2D2E20F User Manual

53
Determines to accept or ignore an active Run command from Remote during power up.
No.
Name
Setting Range
Default
b1-10
Run Command at Power up
0,1
0
0 : Ignore
Drive ignores an active run command during power up.
Note: The LED indicator blinks when there is an active Run command from Remote during power up. The drive can
start only when the Run command is removed and entered again.
1 : Accept
Drive accepts an active Run command from Remote during power up and starts the motor
immediately
WARNING! The drive will run the motor immediately at power up if there an active Run command from Remote.
Ensure the protection measures are taken and clear all personnel from the electrical connections and the running
machinery prior to switching command sources. Failure to comply could cause serious injury.
 b1- 12 Allowing Local/Remote selection during run
No.
Name
Setting Range
Default
b1-12
Allowing Local/Remote selection
during run
0,1
0
0 ：Disable
Local / Remote cannot be switched even the Local / Remote terminal is ON during run.
1 ：Enable
Local / Remote can be switched when the Local / Remote terminal is ON during run.
For the sake of safety, if the command has been switched from Remote to Local, the drive will remain
frequency and run command from remote side, but if the command has been switched from Local to
Remote, the drive will operate depends on the frequency and run command from remote side
immediately. (Parameter b1-12 is not limited by b1-05)
WARNING! Please make sure the frequency and run command is correct when switching Local to
Remote during run.
 b1- 13 Forward/Reverse Selection from keypad
No.
Name
Setting Range
Default
b1-12
Forward/Reverse Selection from keypad
0,1
0
0 ：Disable

LiteOn EVO600043S2D2E20F Specifications

General

Brand	LiteOn
Model	EVO600043S2D2E20F
Category	Controller
Language	English