Operating Manual
Tangential Rolling System T18F - T27F
1
1 Introduction
Congratulations on choosing a LMT Fette tangential rolling system. This tool offers
decisive advantages in terms of economic viability and efficiency and sets new stand-
ards in chipless thread forming.
Setting up and working with the tangential rolling system is very easy. Only a short
training period is needed to ensure cost-effective production.
That said: before using the tool for the first time please make sure to read carefully
and thoroughly through this Operating Manual, paying special attention to the safety
instructions! This will quickly familiarize you with all the features of this tool and help to
prevent damage occurring to the tool and machine.
Expertise help is also available from LMT Fette at any time (see Chapter 13 Service
information).
Notes on this Operating Manual
This Operating Manual (OM) contains all the information which you need to know
about transport, storage, assembly, installation, putting into operation and use. This
Operating Manual does not permit the operation of the processing machine into which
the tangential rolling system is or is to be integrated. Information relating to the said
processing machine is contained in the respective Operating Manual. This Operating
Manual is designed to help you avoid improper handling. Personal safety can only be
ensured if you strictly follow the instructions provided in the Operating Manual. There-
fore, this Operating Manual should be kept in close proximity to the tangential thread
rolling head.
Target group
This Operating Manual is intended for use by appropriately trained and qualified per-
sonnel who are entrusted with the responsibilities of mounting, putting into operation
and using the tangential rolling system.
The following conventions are valid for this Operating Manual:
■ Abbreviations are used in the text. Each chapter provides an explanation of the
abbreviations used when they appear for the first time. The respective abbreviation
is contained in brackets after the term.
Example: Operating Manual (OM)
■ The pages are numbered consecutively in each chapter. Tables and figures are
numbered consecutively.
■ Cross references in the text are linked to additional or more in-depth information.
■ Some chapters specify part numbers. Part numbers with the addition “SP” contain
a reference to the spare parts list (Figure 24 on page 48).
Chapter 2 Safety, page 1, contains generally valid safety instructions relating to haz-
ards which may occur during the operation of the tangential rolling system. Specific
LMT_Bedienungsanleitung_T18F_T27F_e.indd 1 02.08.11 17:40
To Next Page
Loading...