Need help?Do you have a question about the LNC MW5800 Series and is the answer not in the manual?
Introduction to the MW2200 series operation panel.
Description of the MW2800/MW2900 series interfaces.
Description of the MW5800 series standard screen.
Opens machining programs by scanning codes.
Restarts machining from a specific program point.
Manages machining procedures: delete, rename, copy, import/export.
Manages the sequence of machining operations.
Sets PLC, project, and system values.
Configures hardware, operation, system, axis, path, and HMI parameters.
Introduction to the MW2200 series operation panel.
Description of the MW2800/MW2900 series interfaces.
Description of the MW5800 series standard screen.
Opens machining programs by scanning codes.
Restarts machining from a specific program point.
Manages machining procedures: delete, rename, copy, import/export.
Manages the sequence of machining operations.
Sets PLC, project, and system values.
Configures hardware, operation, system, axis, path, and HMI parameters.
General| Input Voltage | 24 VDC |
|---|---|
| Humidity | 10% to 90% non-condensing |
| Protection Class | IP20 |
| Type | Controller |
| Storage Temperature | -20°C to 70°C |
To Next Page
