SW500 Wired Scale Systems, Users
Rev E,October, 2016
Page 20 of 36
CLEAR
While in normal weighing mode, press the CLEAR button to erase a memory
location. See section titled ‘Clear Baseline Setup’ for more information. Also,
press the CLEAR key to clear the number to ‘00’ when at a numeric entry
screen.
STORE/ENTER
This key is primarily used to store a setup as a target setup. See section titled
‘Store Baseline Setup’ for more details. This key is also used when entering
numbers.
COMPARE
Press the COMPARE key to see how close the actual weight is to the target
weight. The values are positive when more weight needs to be added and
negative when weight needs to be subtracted.
TARGET
The ideal weight setup for the car is called the target weight. Press this key to
view the target weight. See sections titled ‘Store Baseline Setup’ and ‘Recall
Baseline Setup’ for details.
ACTUAL
Press this key to view the actual weight.
CG
Press the CG key to enter into Center of Gravity function. Press ‘1’ for Standard
CG or ‘2’ for Vertical CG.
Standard CG
1. Enter axle width.
2. Enter wheel base.
The center of gravity screen is now displayed. To exit the CG mode,
press CG and then any key except ‘1’ or ‘2’.
Vertical CG
1. With the car level on the scale, enter the wheel base.
2. Enter the height you will raise the rear wheels by.
The center of gravity screen is now displayed. To exit the CG mode,
press CG and then any key except ‘1’ or ‘2’.
See the ‘Center of Gravity’ section for more details
To Next Page
Loading...