lntercomp SW500 - Wedge; Target %

SW500 Wired Scale Systems, Users
Rev E,October, 2016
Page 24 of 36
The screen will display the targets entered. Press the “Actual” or the “Compare”
button to see the actual weight on the scales or compare the targets entered to
the weights on the scales.
Wedge
Manually entering values in the Wedge format will allow you to set your targets
with respect to the following parameters: total weight, left side %, rear %, and
wedge %.
1. Press the STORE/ENTER key to enter a target setup.
2. Enter ‘00’ and press STORE/ENTER.
3. Press ‘2’ to select Wedge.
4. Enter the total weight.
5. Enter left side %.
6. Enter rear %.
7. Enter wedge %.
8. Enter the memory location you want to save the setup to (1-99).
The screen will display the targets entered. Press the “Actual” or the “Compare”
button to see the actual weight on the scales or compare the targets entered to
the weights on the scales.
Target %
Manually entering values in the Target % format will allow you to set your targets
with respect to the following parameters: left front %, right front %, left rear %,
and right rear %.
1. Press the STORE/ENTER key to enter a target setup.
2. Enter ‘00’ and press STORE/ENTER.
3. Press ‘3’ to select Target %.
4. Enter the total weight.
5. Enter left front %.
6. Enter right front %.
7. Enter left rear %.
8. Enter right rear %.
9. Enter the memory location you want to save the setup to (1-99).
The screen will display the targets entered. Press the “Actual” or the “Compare”
button to see the actual weight on the scales or compare the targets entered to
the weights on the scales.