71 -
english
Media
+
Configuration of the built-in LAN adapter
➠ Adapter configuration is accessed over the media menu
(see page 70).
You will see an overview of the current settings for the
selected network adapter (for an explanation of the points,
see page 72).
OK Change settings for the network adapter.
Select type of IP configuration.
Manual: Enter your fixed static IP address manually
(see below).
Automatic: Automatic configuration of the IP address
via DHCP server or via multiple protocols
according to UPnP specification (including
DHCP).
OK Proceed.
If manual has been selected under IP configuration:
Enter IP, Subnet mask, Gateway and DNS server
addresses in succession with the numeric keys on
the remote control.
OK Proceed.
You will now see an updated overview of the settings for
the network adapter.
OK End of wizard.
Configuration of a wireless adapter (e.g. WLAN bridge adapter)
➠ Adapter configuration is accessed over the media menu
(see page 70).
You will see an overview of the current settings of the
network adapter (similar to the illustration in the left-hand
column).
OK Change settings for the network adapter.
The TV set now searches for wireless routers.
Red button: Stop search.
After the end of the search:
Select required base station from the options found.
OK Proceed.
If the desired access point is not found:
Red button: Repeat the search. Or:
Yellow button: Specify base station manually, e.g. if the
SSID of the access point is not transferred.
Same procedure as for Rename station,
see page 51.
OK Proceed.
If your wireless network has an encryption, select the
encryption method and then enter the WLAN password
(procedure same as Rename station, see page 51).
➠ Contact your network administrator if you do not
know the WLAN code.
➠ For encryption types supported, see page 147.
For WEP encryption:
Select the WEP index,
OK Proceed.
Select type of IP configuration (see left column).
You will now see an updated overview of the settings for
the network adapter.
OK End of wizard.
OK
NETWORK WIZARD: WIRED
Current adapter settings:
IP configuration Manual
IP address 192.168.2.123
Subnet mask 255.255.255.0
Gateway 192.168.2.1
DNS server 1 192.168.2.1
DNS server 2 192.168.2.1
Additional adapter data:
MAC address 00:09:82:11:99:11
Change settings
To Next Page
Loading...
Need help?
General