8
Place the charging cradle within reach of a
mains power wall socket.
1. Plug the mains power adaptor into the
mains power wall socket.
2. Insert the 2 x AAA rechargeable batteries
supplied, taking note of the ‘+’ and ‘-’
markings inside the battery compartment,
then slide the battery compartment back
on.
3. Place the handset on the charging cradle.
You should let the batteries charge
continuously for at least 14 hours.
Handling the Batteries
• Improper or incorrect use of batteries may cause corrosion or
battery leakage, which could cause personal injury or damage to
property.
• Install the batteries correctly by following the polarity (+ and -)
indications in the battery compartment.
• Use only the types of the batteries which are indicated in this
manual.
• Do not install new batteries with used ones and do not mix dierent
types of batteries.
• Do not dispose of the used batteries as domestic waste. Dispose of
them in accordance with local regulations.
• The display will show the time and the handset number,
e.g. 2, to show it is registered to the base.
• Your phone is now set up to make and receive calls.
for L20DBIG10 only
To Next Page
Loading...
Need help?
General