17
Find the Handset
You can locate the handset by pressing the button on the base unit.
All the handsets registered to the base unit will produce the paging
tone and “PAGING” is displayed on the screen. You can stop the paging
by pressing the button / button / button on any handset or
the button on the base unit again.
If there is an incoming call during paging, the phone will ring
with the incoming call instead of paging.
If only one handset is registered to the base unit, pressing the
button will display “FAILED”.
If two handsets are registered to the base unit, pressing the
button will connect to another handset immediately.
Make an Internal Call
This feature is only applicable when there are at least two registered
handsets. It allows you to make internal calls, transfer external calls from
one handset to another handset and make conference calls. If the called
handset is not answered within 60 seconds, the called handset will stop
ringing and the calling handset will return to standby mode.
Intercom Another Handset
1. In idle mode, press the button and the registered handsets
will display on the screen except the calling handset.
2. Enter the desired handset number to intercom with.
3. The called handset rings. Press the button on the called handset
to establish the internal call.
Call All Handsets
1. In idle mode, press the and the registered handsets will
display.
2. Press the button to ring to all registered handsets.
To Next Page
Loading...
Need help?
General