Configuring the UTRED-16 for logging UTRED-16 User Guide 10
Configuring the UTRED-16 for logging
Before a UTRED-16 logger can be deployed, it must be configured with the parameters
required for starting and recording temperature values.
Loggers can be purchased unconfigured, or pre-configured, ready to be started, using one
of a number of different profiles that are available.
You can check if your logger is already configured or not by briefly pressing the
STOP/Review button.
The logger is already configured to start
If your logger is configured to start it will show either
if the logger was pre-configured for a push-button start, or
if the logger was pre-configured for a Date/Time start.
If your logger shows one of these screens you may skip the configuration process.
The logger is unconfigured
An unconfigured UTRED-16 logger is delivered to you hibernated (i.e. in a state of low
power consumption), and pressing the STOP/Review shows:
followed by and then
If your logger is unconfigured you must set it up with the parameters required for:
l starting and recording temperature values
l triggering alarms
l printing the PDF
To Next Page
Loading...