Configuring the UTRED-16 for logging UTRED-16 User Guide 16
Any alarm condition that is activated will be shown on the PDF, in the software and on the
display.
The section about Reviewing Alarms on page24 shows examples of how this is
represented and reviewed on the display.
Finalizing the configuration
Click Configure to upload the configuration data to the UTRED-16.
When the configuration is complete, unplug the UTRED-16 from the USB socket and
replace the protective cap.
If you wish to configure more UTRED-16 units with the same configuration, insert the next
loggers into USB sockets, wait until they are ready for configuration and click Repeat
Configure. Alternatively, you can use the Profile function to configure multiple units with
the same settings.
You can upload the configuration to a UTRED-16 logger as often as required.
To Next Page
Loading...
