Operating the Logger UTRED-16 User Guide 34
The logger has stopped, and no alarms were recorded
during the trip.
Here, the logger has stopped, and an upper alarm was
recorded during the trip.
Resetting the Logger
You can reset a UTRED-16 back to its original READY state. Once reset, recording can be
started again.
When performing this procedure all recordings and statistics stored in the logger
are deleted and cannot be recovered. Please ensure your data has been saved!
All settings in the logger are retained.
For this process to work, the logger must be
STOPPED.
Press and hold the START/Mark button. The READY
symbol will turn on.
When the STOPPED symbol turns off, release the
button within 2 seconds. The logger is now ready to
be started again.
If the button is released while STOPPED is still on, or you wait until the READY symbol
disappears, the display shows STOPPED again, and the logger remains stopped. This
means, the data from the previous trip is still accessible.
The ability to reset a logger is enabled or disabled in the Advanced Settings tab when
configuring the UTRED-16 via LogTag
®
Analyzer.
To Next Page
Loading...
