46
THIS MANUAL IS PROPRIETY OF ECOWIND by LOMBARDINI - ALL FORMS OF REPRODUCTION, PARTIAL OR OTHERWISE, IS STRICTLY PROHIBITED
G
B
Fig. 85
OK
OK NO
ASSEMBLY AND INSTALLATION - 3
Step Description
8 During the SPLIT fastening phase, accurately check if the latter is xed as shown in gure 85, pos. 1.
If the wall inside the cab is tilted on the front, use two bored spacers D with a min. internal Ø of 6.5 mm, (not supplied
due to the continuous dimensional variability H).
They must be inserted in the two lower pins P on the counter frame, as shown in g. 78, pos. down.
WARNING!
It is strictly forbidden to x the SPLIT as shown in g. 85, pos. 3.
Non-observance of this regulation could lead to drainage problems of the condensation produced
by the SPLIT that may leak inside the cab.
Lombardini S.r.l declines all responsibility for damage to persons or things caused by non-observance of this
regulation.
To Next Page
Loading...
