Using the Main Menu15
To access the Alarm Status menu:
1. From the Live View display, right-click to open the Quick Menu, then click Main Menu.
2. Click INFORMATION, then click the Alarm Status tab.
The following alarms are shown in the Alarm Status menu:
• No HDD: No Hard drive is detected.
• Disk Error: Hard drive error detected.
• Disk Full: Hard drive is full.
• Net Disconnection: System is not connected to the network (offline).
• IP Conflict: More than one device on the network is using the same IP address.
• MAC Conflict: More than one device on the network is using the same MAC address.
• Video Loss: Shows disconnected channels.
• Motion: Shows channels with active motion alarms.
15.11.6 Online User
The Online User menu shows a list of users connected to the system using computers or mobile
devices.
To access the Online User menu:
1. From the Live View display, right-click to open the Quick Menu, then click Main Menu.
2. Click INFORMATION. Click the Network tab on the side panel, then Online User on the
top panel.
15.11.7 Network Load
The Load menu shows you the network traffic your system is sending and receiving.
To access the Load menu:
1. From the Live View display, right-click to open the Quick Menu, then click Main Menu.
2. Click INFORMATION. Click the Network tab on the side panel, then Network Load on the
top panel.
#LX400111; r. 5.0/56647/56647; en-US 86
To Next Page
Loading...
