Using the Main Menu16
2. Click , then click EVENT. Click the ALARM OUTPUT tab on the side panel.
To control alarm output devices:
• To enable alarm output devices, select Auto or Manual for each device you would like to ena-
ble. Select Stop to disable the alarm output device. Click Apply to save changes.
• To manually disable activated alarm devices, click OK next to Alarm Release.
16.4.14 Configuring Pre-Recording
The system can pre-record video when motion detection events occur. This will ensure that the
system records the entire event when motion is detected. By default, the system pre-records 4 sec-
onds of video every time motion is detected.
NOTE
Ensure you have set your preferences for motion detection (see 12 Motion Detection, page 42 for details).
To configure pre-recording:
1. From the Live View display, right-click to open the Quick Menu, then click Main Menu.
#LX400113; r. 2.0/56306/56316; en-US 89
To Next Page
Loading...
Need help?
General
