36
2. Real Time Mode
• From Real Time mode, press C key to display the Alarm time. Press D key to display Month,
Day and Weekday.
• Turn On/Off the “Alarm” and “Hourly Chime”.
a. From Real Time mode, press and hold C key, then press B key to turn On or Off the
Alarm, the indicator “Ref 2” will display for Alarm On.
b. From Real Time mode, press and hold C key, then press B key to turn On or Off the
Hourly Chime. (When all the Weekday display is shown, the Hourly Chime is turned On,
if the Weekday display is not shown, the Hourly Chime is Off.)
Chronograph Mode
• The Chronograph display range is 23 hours, 59 minutes and 59 seconds.
• The Chronograph start counting base on 1/100 seconds. After running for 30 minutes, it will
count by per second.
• To measure time with Chronograph
a. Elapsed Time counting:
From Chronograph mode, press D key to start running, press D key to stop, press D key
again to re-start running, press D key to stop again, then press C key reset to zero value.
b. Split Time counting:
Press D key to start running, press C key to split count and show the time, press C key to
release split count and continue running, press D key to stop running and show the total
Chronograph time, then press C key reset to zero value.
c. Double Runner Split Time counting:
Press D key to start running, press C key to split count for 1st runner finishes and show
the time of 1st runner. Press D key again to stop count for 2nd runner finishes, then
press C key to release split count and show the counting time of 2nd runner, finally press
C key to reset the value to zero.
• When the Chronograph running reaches to the maximum counting value, it will go to all “zero”
value and re-start counting again, press D key to stop the Chronograph.
• When Chronograph is running, press B key to exit and return to Real Time mode, the
Chronograph is still running at the back.
To Next Page
Loading...