28
BACKHOE REMOVAL
Caution :
Move the backhoe to flat, firm and wide place to remove the equipment.
Caution :
Do not allow to be removed without bucket and stabilizers. Also, dump the remaining
material from the bucket to empty.
Caution :
Use other lifting equipment to remove when the backhoe has damage.
Step 1.
Move the tractor to backhoe storage place.
Step 2.
Use the inner two levers to lower the stabilizers until they contact to the ground. Use the boom and
dipper stick control lever to raise the boom & dipper stick completely.
Step 3.
Center the boom and then lock the swing with lock pin.
Step 4.
Using the control levers, position the dipper stick vertically, curl the bucket until its bottom is level
with the ground, and lower the boom until bottom of the bucket rests on the ground.
Step 5.
Remove the lock pin from the frame.
To Next Page
Loading...