Set the frequency to start DC braking. When the frequency is
reached, the inverter starts deceleration.
If the dwell frequency is set lower than the DC braking frequency,
dwell operation will not work and DC braking will start instead.
• Note that the motor can overheat or be damaged if an excessive amount of DC braking
is applied to the motor, or DC braking time is set too long.
• The motor can be overheated or damaged. The maximum value of DC braking is
limited to the rated current of the inverter.
4.15.3 Free Run Stop
When the Operation command is off, the inverter output turns off, and the load stops
due to residual inertia.
To Next Page
Loading...