LSIS LSLV-G100 - Multi-Step Acc;Dec Time Configuration

Acc/Dec Time Based on Operation Frequency – Setting Details
Code and
Features
Description
bA.08
Ramp T Mode
Set the parameter value to 1 (Delta Freq) to set Acc/Dec times based
on Maximum frequency.
Configuration
Function
0
Max Freq
Set the Acc/Dec time based on maximum
frequency.
1
Delta Freq
Set the Acc/Dec time based on operating
frequency.
If Acc/Dec times are set to 5 seconds, and multiple frequency
references are used in the operation in 2 steps, at 10 Hz and 30 Hz, the
time to accelerate will be as follows.
4.8.3 Multi-step Acc/Dec Time Configuration
Acc/Dec times can be configured via a multi-function terminal by setting the ACC
(acceleration time) and dEC (deceleration time) codes in the Operation group.
Group
Code
Name
Setting
Setting Range
Unit
Operatio
n
ACC
Acceleration time
5.0
0.0–600.0
sec
dEC
Deceleration time
10.0
0.0–600.0
sec
bA
70–82
Multi-step
acceleration time
1–7
0.0
0.0–600.0
sec
71–83
Multi-step
deceleration time
1–7
0.0
0.0–600.0
sec
In
65–69
Px terminal
setting options
11
XCEL-L
0–52
-
12
XCEL-M
49
XCEL-H
89
Multi-step
command delay
time
1
1–5000
ms