LSIS S100 Series - Chapter 2. Specifications

3
Introduction
Manual Composition
2.1 Trips and Warnings
2.1.1 Failure/Warning List
2.1.2 Troubleshooting Fault Trips
2.2 Troubleshooting Other Faults
3.1 Regular Inspection List
3.1.1 Daily Inspections
3.1.2 Annual Inspections
3.1.3 Bi-annual Inspections
3.1.4 Check Input/Output Module
3.1.5 Replace Cooling Fan
3.2 Storage and Disposal
3.2.1 Storage
3.2.2 Disposal
This section explains troubleshooting
fault trips and other common faults.
If problems are not solved, please
contact your vendor or LSIS.
This section provides information on
how to maintain the inverters on a
regular basis for different time
periods.
When there is a problem in the
inverter, please check the
input/output module. This is the basic
method to check the hardware.
This section covers check points
when there is a problem in the
inverter.
Then check the parameter settings
using basic operations and the trip
records.
1.1 Before You Think It Failed
1.2 Basic Operations
1.3 Change Parameter
1.3.1 Change Carrier Frequency
1.3.2 Initialize all Parameters
1.3.3 Read and Write Parameters
1.4 Monitor Fault Trip
1 Basic Checklist
2 Troubleshooting
3 Maintenance