5
Preface to the Manual
The operation instructions contain important information for the safe and proper operation of an
automated lubrication system. It is recommended that a user read the instructions carefully prior
to operation, Lubecore will not be held liable for damages and failures resulting from non-
observance of these instructions. All instructions must be completed respective to national
regulations pertaining to accident and environmental protection.
Disclaimer:
Lubecore International reserves the right to modify, correct, update, expand or delete items,
descriptions, directions, explanations from this document without prior or direct notification of
distributors, customers, dealers, end users or persons whether spoken or written.
All rights reserved:
This document is the property of Lubecore International, Inc. No part of this document may be
reproduced or altered, copied and/or published by means of printing, photocopying, microfilm,
scanning or any other form of electronic means without prior written permission from Lubecore
International, Inc. This applies to all drawing, diagrams, charts, schedules etc. You are
requested to contact Lubecore technical department for information concerning items not
discussed in this document. Whilst this document has been prepared with the greatest possible
care Lubecore International, Inc. cannot accept responsibility for errors and/or omissions.
Responsibility to ensure the safe operation of the automated lubrication system, the end user is
responsible for the following:
1). The automated lubrication system shall be operated only for the intended use and its design
shall neither be modified nor transformed.
2). The automated lubrication system shall be operated properly only if it is in a proper
functioning condition and if it is operated in accordance with the maintenance requirements.
3). Personnel must be familiar with this operation manual and the safety instructions mentioned
herein and observe these carefully.
4). Wastes (e.g. used oil, detergents, lubricant) must be disposed in accordance with relevant
federal, state, provincial and territorial environmental regulations.
Service:
Lubecore offers users full service in the form of advice, on-site installation assistance, training,
etc. if requested. In case of inquiries pertaining to maintenance, repairs and parts, Lubecore
requires model specific data to enable us to identify the components of the automated
lubrication system. Lubecore will not accept any liability for damages caused by the misuse of
the designed automated lubrication system and/or the repair of said system by using any other
parts other that Lubecore International original (OEM) parts.
To Next Page
Loading...