Lucent Technologies Enhanced VR Series Batteries
Issue 5 December 1998 Ordering Information 3 - 1
3 Ordering Information
Configurations
A 2-volt, 125Ah cell is the building block used to construct the
Enhanced VR family of batteries. These modules may be
mounted in a variety of ways.
• 2VR250E, 2VR375E, or 4VR125EL batteries are mounted
in a J85504C-1 VR battery stand to create 24- and 48-volt
stand-alone strings.
• Installed in a four-shelf battery stand, these batteries are
used as an integral part of the Lucent Technologies
Evolutionary Control System (ECS) J85500D-2 and
J85500D-3 battery plants.
• 2VR250E, 2VR375E, or 4VR125EL batteries are mounted
using special shelving in a standard 23-inch SLC
96/5 network bay frame (J85500D-2 or J85500D-3
applications).
• 4VR125E modules are mounted in the bottom of a Lucent
Technologies 80-type (A, D, E, G) cabinet.
The 4VR125E, 4VR125EL, 2VR250E, and 2VR375E battery
modules are shipped with insulated terminals. Nuts, washers,
inter-module and inter-tier connectors, as well as lifting handles
and NO-OX-ID “A” compound, are packaged in a separate
container on the shipping pallet.
In addition, an optional configuration for a 23-module operation
is available for RSM or ORM switching applications having a
maximum input voltage requirement of 53 volts. This
configuration is not available for the 4VR125E or 4VR125EL.
To Next Page
Loading...
Need help?
General
