Lucent Technologies Enhanced VR Series Batteries
Issue 5 December 1998 Installation 6 - 1
6 Installation
Introduction
This section describes the procedures for installing the Enhanced
VR Series batteries. Please review the safety precautions in
Section 4 before handling the batteries.
Installation
Tools,
Materials, and
Test Equipment
The following tools, materials, and test equipment are
recommended for installation, operation, maintenance, and
testing of the batteries:
• Chemical and impact resistant safety goggles and safety
hard hat
• Acid resistant gloves, rubber overshoes, and apron
• Lime and/or soda (sodium bicarbonate or sal soda)
• Class C fire extinguisher
• Cleaning cloth
• Insulated socket and a torque wrench capable of measuring
60 inch pounds
• Insulated nut driver
• Combination wrench set, screwdrivers
• Sandpaper or abrasive cloth
• Thermocouple-based or infrared-based temperature
measuring device
• Digital multimeter (DMM) with an accuracy of 0.05 percent
on the dc scale
• DC power source capable of supplying 2.5 volts per
2VR250E or 2VR375E battery or 5.0 volts per 4VR125E
battery
Product Manual
One product manual is included with each pallet of batteries.
Order additional product manuals by calling Customer Service
To Next Page
Loading...
Need help?
General
