LUKO FD-S60L - 3.13 Electric Diagram

Page
14
of
35

It is forbidden to connect the power supply beyond the specified voltage and frequency;

Before the connecting the power supply, the electrical point should be checked to ensure that
its voltage and frequency fluctuation does not go beyond ±10%;

Unit must be grounded and turn off power during checking work.
3.12 Sensitive elements connection
The installation of temperature and humidity detection devices should follow the requirements as
below：

Temperature and humidity detection devices should be installed above ground 1m - 1.5m, to
ensure the device can detect the humidity of the dehumidifying area;

Detection device should be installed away from dry air or wet air or airflow from outside;

Temperature and humidity detectors should stay away from cooling equipment,

do not directly exposed to sunshine place, as the change of the temperature will affect the
actual assessment;

External control system must be compatible with the low voltage control circuit of
dehumidification equipment.
3.13 Electric Diagram