Page
20
of
35
Humidity Set:
Press to reduce humidity, press to raise humidity (1% change on each press).
Temperature Set:
Only for the available system working mode.
Filter:
Long press & for 5 seconds to display the run time, wait for 5 seconds to exit.
Long press for 10 seconds to clear the alarm and reset the time.
B. Factory Parameters
Factory parameters setting:
Long press for 5 seconds to enter the factory parameters setting mode: the parameters code R, P,
O, H, C, A, D, F will appear;
Press or to select the parameters code R, P, O, H, C, A, D, F;
Short press to set the code;
Press or to adjust the code value;
Short press to save the code value;
Short press to exit without saving during the code value setting or return to the previous page;
Long press & & for 3 seconds to reboot the controller’s settings;
10 seconds without any changes in setting, the value will not be saved and exit to the home screen.
To Next Page
Loading...
