WEIVER 2.0 Manual
Weiver 2.0
/ Operations Manual
4
been subjected to excessive shock by being dropped, or the
cabinet has been damaged If the apparatus fails to operate in
accordance with the operating instruction
Warranty Period
Lumantek Test & Measurement and Broadcasting products
normally carry a 1-year limited warranty (including labor and
parts) Unless noted, Lumantek Digital Media products normally
carry a 1-year limited warranty (including labor and parts).
Return Material Authorization Policy
No product may be returned directly to Lumantek without rst
contacting Lumantek for a Return Material Authorization (“RMA”)
Code. If it is determined that the product is defective, you will
be given an RMA Code and instructions for product return for
servicing or replacement. An unauthorized return such as where
an RMA Code has not been issued, the product will be returned
to you at your expense. Authorized returns are to be shipped
prepaid and insured to the address on the RMA in an approved
shipping container (original box and packaging materials or
similar). To request an RMA Code, please visit on http://www.
lumantek.com/support/rma_services_instruction.html
Warranty Limitations
Lumantek’s limited warranty provides that, subject to the
following limitations, each product will be free from defects
in material and workmanship and will conform to Lumantek’s
specication for the particular product.
Limitation of Remedies
Your exclusive remedy for any defective product is limited to the
repair or replacement of the defective product.
Lumantek may elect which remedy or combination of remedies
to provide in its sole discretion. Lumantek shall have a reasonable
time after determining that a defective product exists to repair
or replace a defective product. Lumantek’s replacement product
under its limited warranty will be manufactured from new and
serviceable used parts. Lumantek’s warranty applies to repaired
or replaced products for the balance of the applicable period of
the original warranty or ninety days from the date of shipment
of a repaired or replaced product, whichever is longer.
Limitation of Damages
Lumantek’s entire liability for any defective product shall in no
event exceed the purchase price for the defective product. This
limitation applies even if Lumantek cannot or does not repair or
replace any defective product and your exclusive remedy fails
of its essential purpose.
No Consequential or Other Damages
Notwithstanding anything else in this policy or otherwise,
Lumantek will not be liable with respect to the products
under any contract, negligence, strict liability or other legal
or equitable theory (i) for any amount in excess of the
purchase price for the defective product or (ii) for any general,
consequential, punitive, incidental or special damages. These
include loss of recorded data, interruption of use, the cost of
recovery of lost data, lost prots and the cost of the installation
or removal of any products, the installation of replacement
products, and any inspection, testing, or redesign caused by
any defect or by the repair or replacement of products arising
from a defect in any product. This section does not limit liability
for bodily injury of a person.
Your Use of the Product
Lumantek will have no liability for any product returned if
Lumantek determines that:
The product was stolen from Lumantek.
The asserted defect:
- Is not present,
- Cannot reasonably be xed because of damage occurring
when the product is in the possession of someone other than
To Next Page
Loading...
Need help?
General