Lumantek WEIVER 2.0 User Manual

WEIVER 2.0 Manual
Weiver 2.0
/ Operations Manual
88
- Command header and error check data is not available.
- Include texts to UDP packet data and send it to ‘WeiverEx’.(Each character size is 2-byte)
- Ports from 50400 and 50500 are selectable from ‘WeiverEx’
- ‘WeiverEx’ responses back to the port that server used sending such data.
- CANNOT process multiple number of commands repeatedly.
- Two ‘UDP Event’ commands are available, ‘set_eventle’ and ‘get_eventle’.
1) ‘set_eventle’ event description
- Must have spaces between the ‘set_eventle’ and event description.
- Event Description: is one that goes into ‘lename.wev’, maximum text up to 99. do NOT use
comma( , ).
2) “set_eventle”
- Basic event description if specic event description is not available.
3) “get_eventle”
- Check whether the ‘Event’ has occurred or not.
4.3 / Description of UDP event during recording
- Response to “set_eventle”
1) If successful : ok(event description)
2) If failed :
“fail(invalid state)”
“fail(event overlap)”
- Response to “get_eventle”
1) If successful : “ok(event description)”
2) If failed : “fail(invalid le)”
- Response to ‘set_eventle’ and ‘get_eventle’
“fail(invalid command)”

Lumantek WEIVER 2.0 Specifications

General

Brand	Lumantek
Model	WEIVER 2.0
Category	Measuring Instruments
Language	English