Instruction Manual
______________________________________________________________________
_____________________________________________________________________________
BE6043-16 Stand Alone Multipoint System LumaSense Technologies A/S
Page 19 of 25
performing a monitoring task. However, the data in Display Memory
can be copied into and stored in the Monitor’s Background Memory.
For further details on the Gas Monitor Memories and handling please
refer to the User Manual supplied with the Gas Monitor.
Please be aware that the finite memory capacity includes both the
Display and Background Memory.
When you start a new monitoring task the following warning is
displayed WARNING: DISPLAY MEMORY WILL BE DELETED to
remind you to store any data that is presently stored in the Display
Memory, any data already stored in Display Memory will be deleted
when a monitoring task is started.
Press MEASURE on the Front Panel and follow the text that
appears on the screen to start the measurement.
Please note: if you do not use one of the “select” keys within a
short time after the above text appears, the Monitor will
automatically stop operating in Measure mode (the light-emitting
diode in the MEASURE key switches off). If this happens, just press
MEASURE again.
5. To start the measurement immediately, press S1.
To delay the start, press S2.
The following warning then appears on the display:
To Next Page
Loading...
Need help?
General