Luminex 200 Installation Manual
2
xMAP Technology
Reagents
• Classification calibration microspheres (CAL1)
• Reporter calibration microspheres (CAL2)
• Classification control microspheres (CON1)
• Reporter control microspheres (CON2)
• xMAP sheath fluid
Required Laboratory
Reagents
The following items are necessary to run the Luminex 200 system.
They are not provided by Luminex.
• Household bleach
• 70% isopropanol or 70% ethanol
• Mild detergent
• Distilled water
Luminex Software Luminex software provides complete control of the system and
performs data analysis. The PC accompanying your system is
preloaded with the Luminex software. However, we supply a
software CD should you need to reinstall the software.
This software requires a dedicated system. Unauthorized additional
software is prohibited and may result in improper operation of the
system.
Safety Symbols Please become familiar with the information in this chapter before
installing the equipment. Do not perform procedures on your
Luminex 200 system that are not specifically contained in this
manual, unless you are directed to do so by Luminex Technical
Support.
These symbols describe warnings, cautions, and general information
used in the operation of this instrument. Some of these symbols are
further defined under “Safety Precautions.”
To Next Page
Loading...
Need help?
General