Luminex 200 Installation Manual
4
Safety Precautions Read the following safety information before setting up or using the
Luminex 200 system. A user should be present during operation.
This system contains electrical, mechanical, and laser components
which, if handled improperly, are potentially harmful. In addition,
biological hazards may be present during system operation.
Therefore, we recommend that all system users become familiar with
the specific safety advisories below, in addition to adhering to
standard laboratory safety practices. The protection provided by the
equipment may be impaired or the warranty voided if the system is
used in a manner not specified by the instructions or by Luminex
Corporation. Various informational labels appear on the back of
Luminex system components. Refer to the Luminex System User
Manual for more details about the labels.
This caution label appears on the back of the Luminex 200 analyzer
and on the Luminex XYP instrument.
.
Figure 1. Fuse Caution Label
Do not perform any maintenance or cleaning of the system’s
electrical components, with the exception of replacing fuses.
This label appears on the back panel of the Luminex 200 analyzer,
the Luminex XYP instrument, and the Luminex SD system
Figure 2. CE Label
The Luminex 200 analyzer, XYP instrument, and SD system comply
with European Union (EU) safety requirements and, therefore, may
be marketed in the Europe Single Market.
The Luminex 200 analyzer, XYP instrument, and SD system have
been tested by Underwriter Laboratories, Inc.® (UL).
To Next Page
Loading...
Need help?
General