HOW TO COPY A PROCESS ENGINE
Once you have created your rst process engine, select it by clicking on the tick box in the top left corner. A
handle appears at the bottom centre of the process engine.
Click and drag the handle down, to select other process engines.
The LumiNode will automatically increase the universe number, and the DMX port, for each following
process engine. This allows you to create a complete conguration in a snap!
The DMX/RDM page is divided in two sub menus:
PORT SETTINGS
The port settings oer you to:
Add a legend to a port to easily identify what is connected to it. This will also update the tooltip on the
conguration page of the process engine.
Enable Sync mode: when enabled the DMX output framerate is matched to the input framerate. If the
source used for this port is capable to send an Art-Net or sACN sync packet this will be used.
Redundant Slave: when enabled the DMX port listens to incoming DMX from another port or another
node and will start outputting if no DMX input is detected. When DMX redundant slave is enabled RDM is
automatically disabled. See the chapter about DMX redundancy further on in the manual.
Enable RDM, enabling RDM allows RDM trac to be transported to or from an outlet over the network
and back.
x Adaptive discovery. When RDM is enabled, it is possible to enable adaptive d iscovery. This will
continuously check for new and disappeared RDM devices on the output.
x Interweaving. Interweaving is enabled by default. Interweaving is only available when the FPS is set
lower or equal to 34 FPS. Interweaving makes that RDM messages are interweaved with DMX. If your
xture does not support interweaving or the RDM packets you are sending are too large you would
disable RDM interweaving. For example, with a RDM based follow-spot system interweaving needs to
be disabled.
x ArtRDM universe. The ArtRDM universe is the universe which is used for ArtTOD and ArtRDM packets.
By default, this will be matched to the Art-Net universe of the rst Art-Net input of your process
engine.
Scroll down and click Save to save your settings.
At the bottom of the DMX/RDM page, you can nd a button to force an RDM discovery in case this is
required.
12
To Next Page
Loading...
Need help?
General
