Alternatively, the LumiNode series are 802.3af compliant (PoE), so that each LumiNode will act as a
PD (Powered Device) and can be powered by any compliant PSE (Power Sourcing Equipment) such as
Ethernet switch, midspan and PoE injector. All models can only be powered with PoE via ETH2!
To get the LumiNode 4
DIN
online in your system, connect either port ETH1 or ETH2 to a computer, or to a
port of an Ethernet switch.
Only port ETH2 on the rear of the unit can be used to power the unit through PoE. Check the port labelling
for a better identication.
There are various LEDs on the LumiNode 4
DIN
. Here is a list of the LEDs, the possible colours, and the
meaning of each colour:
DMX PORT STATUS MEANING
DMX Input Green Input idle
Green ashing Input active
DMX only (output mode) Cyan Output idle
Cyan ashing DMX activity
DMX + RDM (output mode) Blue Output idle
Blue ashing DMX activity
Stream loss Red Source stream lost
Red ashing Source stream lost but still outputting the last received packets
Orange ashing Source stream recovered
DMX redundancy Magenta Output idle
Magenta ashing Output active
NETWORK PORT
Bottom LED (Link) Green Gigabit connection (ashing: Ethernet trac)
Orange 100Mbit connection (ashing: Ethernet trac)
Top LED (Mode) Blue Default colour
Green ashing Device booting
Orange ashing Firmware upgrade in progress
Green blinking Identify in progress
Group colour Corresponding to assigned group/VLAN
POWER
Power/OK LED
Red Device booting
Green Device booted and online
8
To Next Page
Loading...
Need help?
General
