Lumiscope 1133 - 11 MEMORY FUNCTION; Memory Recall

14
11 MEMORY FUNCTION
Memory Recall
1.
Model1133canstore120setsofreadingstotal(60setsin“M1”and60setsin“M2”)andwill
automaticallycalculatetheaverageofthelast3readingsfor“M1”or“M2”.Whenmemoryisfull,the
oldest reading will be replaced by the newest. Memory will not clear even if the batteries are removed;
fig. 11-1
2. After a measurement is finished, or when the device is in standby mode, the user can press
button“M1”or“M2”torecallmemory.Pressbutton“M1”todisplaytheaveragevalueofthelast
3 measurements as shown in Fig. 10-1;
fig. 11-2
3. Pressbutton“M1”again,thedevicedisplays“01”;thenafter1-2secondsthelatestmeasurement
will display as shown in Fig. 11-2;
4. Pressbutton“M1”again,thedevicedisplays“02”;thenafter1-2secondsthesecond-to-the-last
measurement will display.