KEYPAD KP200
2 Parameter list
2-2
no. name unit function factory set your set range of value explanation R W
_15FC First commissioning
150 SAVE Back-up device setup STOP STOP, START STOP = Back-up stopped resp. not
started yet
START = Start back-up
22
151 ASTPR Previous presettings in application data set (ADS) DRV_1
OFF, DRV_1 ... DRV_5, ROT_1 ...
ROT_4, BUS1 ... 3, M-S_1 ... M-
S_4
DRV = Traction and lifting drive
ROT = Rotational drive
BUS = Field bus operation
M-S = Master-/Slave operation
35
152 ASTER Presettings in application data set (ADS) DRV_1 12
154 MOPNM kW Motor type G*
G* 12
155 MOVNM V Motor rated power G*
G* 12
156 MOFN Hz Motor rated voltage 50
0.1 ... 1600 12
157 MOSNM 1/min Motor rated frequency G*
0 ... 100000 12
158 MOCNM A Nominal speed G*
G* 12
159 MOCOS Motor rated current G*
0 ...1 12
160 MOJNM kg m² Motor nominal cos-phi G*
0 ... 100 33
161 SCJ1 kg m² Moment of inertia of motor 0
0 ... 1000 33
162 SCJ2 kg m² Moment of inertia of system (CDS1) 0
0 ... 1000 33
163 ENSC Moment of inertia of system (CDS2) STOP
STOP, START STOP = Self-adjustment stopped
resp. not started yet
START = Start self-adjustment
22
164 UDSWR Enable auto-tuning 1
1 ... 4 33
165 UDSAC Back-up device setup to a user data set 1
1 ... 4 33
166 UDSSL Activate user data set PARAM
PARAM, TERM, SIO, OPTN1,
OPTN2
PARAM = Parameter 165-UDSAC
TERM = Input with function UMx
SIO = SIO control word
OPTNx = Control word of module in
option slot 1 resp. 2
33
To Next Page
Loading...
