Shim will cause fabric
to move this way
tape
(shim)
Check shade tracking
11
Reconnect power to the shade power supply.
Use the programming stylus to run the shade up and down using the adjustment buttons on the
EDU ( ). Re-level if needed. To set Limits from the EDU, proceed to the next section.
Observe: Pay careful attention to the shade roll up to ensure that it does not telescope extremely to
one side or the other. Move the shade up and down multiple times to ensure the fabric does not rub
against the brackets or other obstructions.
Tip: Slight telescoping is normal. However, if the shade is telescoping severely to one side and it is
level, press the “close limit button” ( ), and lower the shade all the way down (past the close limit you
plan to use) using the adjustment buttons on the EDU ( ). Place a piece of tape on the side of the
tube that the fabric is telescoping away from as shown. When finished press the “close limit button”
( ) once. This technique is referred to as “shimming”. The shade will always track towards the side
that the tape (shim) is placed on.
Sivoia® QS roller 64TM Dual Mount Installation instructions
Page 13
To Next Page
Loading...
