Lutron Electronics Sivoia QS - Setting the Close Limit from the EDU

Sivoia® QS roller 64TM Dual Mount Installation instructions
Page 15
12.5
12.6
12.4
12
Setting limits from the EDU (continued)
Setting the close limit from the EDU
Press and hold the “close
limit button” ( ) for 5
seconds. The green LED
on the roller 64 EDU will
flash for 2 seconds, then
go dark, indicating that the
current position has been
stored as the close limit.
Tap the “close limit button”
( ). The green LED on the
roller 64 EDU will turn on
steady, indicating that the
EDU is in “set close limit
mode”.
Adjust the position of the
EDU to the desired close
limit using the clockwise
and counterclockwise
buttons ( ).
Flashing green LED
Press and hold the
close limit button
for 5 seconds
Green LED
Tap the
close limit button
Use the clockwise and
counterclockwise
buttons to move the
EDU